WARNING : PLEASE READ THE ENTIRE MANUAL
BEFORE YOU INSTALL AND USE YOUR NEW FIREPLACE.
FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN
SERIOUS INJURY, DEATH OR PROPERTY DAMAGE.
WARNING : DO NOT OVERFIRE THE FIREPLACE. IF
FIREPLACE OR CHIMNEY CONNECTOR GLOWS,YOU
ARE OVERFIRING.
WARNING : DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
WARNING : OPEN THE DAMPER BEFORE STARTING
THE FIRE.
WARNING : IF THE FIREPLACE IS NOT PROPERLY
INSTALLED, A HOUSE FIRE MAY RESULT. TO REDUCE
THE RISK OF FIRE, FOLLOW THE INSTALLATION
INSTRUCTIONS.
WARNING : THE FIREPLACE MUST BE CONNECTED TO
A CHIMNEY COMPLYING WITH THE REQUIREMENTS
FOR TYPE HT CHIMNEYS IN THE STANDARD FOR
FACTORY-BUILT CHIMNEYS FOR RESIDENTIAL TYPE
AND BUILDING HEATING APPLIANCES, UL 103.
CAUTION : RISK OF FIRE DO NOT ENCLOSE THE
SHIELD. REMOVE THE INSULATION SHIELD BEFORE
ENCLOSING CHIMNEY IN ATTIC SPACE.
North American Designed & Manufactured by:
NICO | Suspended Hood with Base
Wood Burning replace
MODEL: NICO
SERIAL NO.: YYMMDD-VNCO4SF-XXX
INSTALLER: Leave this manual with the appliance. Custom Fireplace Design Inc.
CONSUMER: Retain this manual for future reference. 5230 Harvester Rd., Burlington, ON Canada, L7L 4X4
Fireplace has been tested and certied to
meet the standards of:
UL 737- Standard for Fireplace Stoves.
CAN/ULC - S610 - Standard for Factory-built
Fireplace Systems
Certied under : ICC-ES PMG-1574
WARNING : IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION,SERVICE, OR MAINTENANCE CAN CAUSE
INJURY OR PROPERTY DAMAGE.
FOR USE WITH SOLID FUEL ONLY (WOOD OR COAL).
BURN DRY, SPLIT, SEASONED WOOD FUEL.
WARNING : FIREPLACE EQUIPPED WITH DOORS
SHOULD BE OPERATED ONLY WITH DOORS FULLY
OPEN OR DOORS FULLY CLOSED. IF DOORS ARE LEFT
PARTLY OPEN, GAS AND FLAME MAY BE DRAWN OUT
OF THE FIREPLACE OPENING, CREATING RISKD FROM
BOTH FIRE AND SMOKE.
Gas connection and installation (if applicable) shall comply
with the National Fuel Gas Code ANSI Z223.1.
The construction of the masonry hearth must comply to NFPA
211,CAN/CSA A405 (Design and Construction of Masonry
Chimneys and Fireplaces) or to National Building Code of
Canada.
Install and use only in accordance with Custom Fireplace
Design Inc.’s installation and operating instructions.
Follow manufacturer’s installation instructions for precautions
required for passing a chimney or chimney connector through
a combustible wall or ceiling and follow the local building
codes.
Contact Local Building or Fire ofcials about restrictions and
installation inspection requirements in your area.
INSTALLATION | OWNER'S MANUAL
* THE IMAGE SHOWN HERE IS FOR FIREPLACE DESIGN PURPOSE ONLY,
GLASS ACCESSORIES NOT TO BE USED FOR WOOD BURNING. *
To Next Page
Need help?
General