Need help?Do you have a question about the vita V60 i-Line and is the answer not in the manual?
General| Brand | vita |
|---|---|
| Model | V60 i-Line |
| Category | Laboratory Equipment |
| Language | English |
Explains the meaning of various safety symbols used throughout the manual, such as hazardous voltage and hot surfaces.
Lists the built-in safety and monitoring features of the furnace, like temperature and vacuum monitoring.
Provides guidelines for selecting a suitable installation site, considering ventilation, heat resistance, and accessibility.
Describes how to activate the standby mode, including lift retraction and chamber heating to standby temperature.
Presents an overview of the program interface, detailing various buttons and their functions related to firing programs.
Explains how to begin the selected firing program by pressing the START button.
Adjusting time and temperature for the pre-drying phase of a firing program.
Modifying the initial temperature ramp rate and hold duration in a firing program.
Adjusting the second temperature ramp rate and hold duration in a firing program.
Configuring the cooling temperature and hold time for a firing program.
Using the save button to permanently store changes made to program parameters.
Explains how to set the end temperature and its impact on heating rate and rise time.
Details how to set the rise time and its relationship with heating rate and vacuum pump operation.
Describes how to set the heating rate and its effect on rise time and vacuum pump operation.
How vacuum pump activation and deactivation depend on program temperatures and rise times.
Explains the 'Lock is open' state, allowing modifications and saving of program parameters.
Details the 'Lock is closed' state, where changes require a PIN for saving.
Reset all device settings and programs to their original factory defaults.
Enable temperature calibration and verification using the silver test function.
Explain how to set or enter a PIN to lock or unlock device settings.
Explains the procedure for calibrating the firing chamber temperature using the VITA Silver Test Set.
Describes the error message indicating a problem with the temperature sensor and its potential causes and corrections.
Explains the error message for failed vacuum achievement and troubleshooting steps.
Details the error message related to damage to the heating element or muffle, including repair advice.
To Next Page
