INSTRUCTIONS
A
B
C
D
E
F
Also included:
x1
150ml
/5oz
breast like
feeding bottle
x1
240ml
/8oz
breast like
feeding bottle
2 in 1 combination steriliser
CONTENTS:
A) STERILISER LID
B) STERILISER BASE
C) BOTTOM BASKET
D) UPPER BASKET
E) CENTRAL SUPPORT POST
F) TONGS
USING YOUR STERILISER
IN COLD WATER
STERILISATION MODE
WARNING!
INSTRUCTIONS FOR USE AND CARE.
IMPORTANT, READ CAREFULLY AND
RETAIN FOR FUTURE USE.
• Keep the steriliser out of reach of children.
• Always follow loading instructions and do not
overload.
• Always use the steriliser on a hard, level and
stable surface.
• Before placing items into the steriliser ensure
they are suitable for cold water sterilisation
• The lid is not leak proof and the contents will
spill out if the unit is allowed to tip.
• In the event of any spillage, wipe up the
solution immediately.
• Do not attempt to transport the unit with any
sterilising solution inside.
• Do not use abrasive agents or scourers to clean
the steriliser.
• Cold Water Sterilisation on its own is not
a substitute for thorough cleaning. Always
clean feeding bottles, teats and accessories
thoroughly before sterilising them.
• Before sterilising, thoroughly wash all items in
warm soapy water and rinse.
LOADING AND OPERATION OF YOUR
COLD WATER STERILISER
• You can cold water sterilise up to 6 standard or
4 breast like bottles at a time.
• Remove both lower and upper baskets from
the steriliser. Separate the lower basket
from the central support post by twisting it
anticlockwise.
• Place the steriliser on a hard, level and stable
surface in a secure location where it cannot be
reached by children.
• Following the instructions from the sterilant
manufacturer, make up your sterilising solution
accordingly in the steriliser base.
• Place your fully disassembled bottles, teats
and/or accessories into the solution ensuring
that there are no trapped air bubbles.
• Flip the lower basket upside down and place
it on top of the contents in the steriliser
base. This acts as a weight and ensures full
submersion.
• Leave the equipment submerged in line with
the sterilant manufacturers instructions.
AFTER COLD WATER
STERILISATION
• Wash your hands thoroughly before touching
sterilised items.
• Once you are ready to remove your items,
carefully remove the steriliser lid.
• Remove the items you need and carefully shake
off any excess solution.
• Assemble bottles/accessories accordingly
• Once bottles and accessories are removed
from the steriliser they must be assembled and
used immediately or re-sterilised.
• A fresh sterilising solution should be made up
every 24 hours.
www.vitalbaby.com
Made in China to Vital Baby
®
specifications. Vital Innovations Limited, Hatfield, Herts, AL10 9EW,
United Kingdom.
Vital Baby
®
is a registered trademark. NURTURE™ is a trademark. Patent protected. Design Rights.
© Vital Innovations Ltd 2019.
To Next Page
Need help?
General