6
Illustration 11. Illustration 12.
Plug the power cord into a power outlet.
Make sure that the mattress tubes are not bent or twisted.
Start the pump by using green button. Position 1 (on) - the pump is switched on. Position 0
(off) - pump is switched off.
Using the knob, set the maximum level of mattress inflation.
FIRM - is the degree of mattress inflation, the mattress can be described as hard.
SOFT - is the degree of mattress inflation, the mattress can be described as soft.
Illustration 13.
Low pressure warning lamp lights up when inside the mattress is low pressure, i.e. during the
pumping process.
Normal pressure lamp lights up when inside the mattress is pressure in accordance with
parameters set on the pump.
After about 30 minutes, when the mattress is already inflated, place mattress end laps under
the mattress of your bed.
Put sheet on the mattress.
Now the patient can lay on the mattress.
Using the knob, set the desired degree of mattress inflation for patient comfort .
Low pressure warning light
Lamp normal pressure light
To Next Page
Loading...