The VITEK VT-7125 is a burr coffee grinder designed to offer various grinding degrees for different coffee brewing methods. The finer the grind, the quicker the coffee is prepared, but the taste of the ready drink may be bitter and harsh. Conversely, if the grind is too coarse, the ready drink will taste weak and watery. With a properly chosen grind degree, the coffee will be strong but without a bitter aftertaste.
Description
The device includes the following components:
- Ground coffee container
- Container lid
- Container lock
- Ground coffee scale
- Ground coffee amount control knob
- Coffee grinder ON button «U»
- Coffee bean container lid
- Coffee bean container
- Detachable upper millstone
- Coffee bean container installation place
- Grinding degree control knob
- Body
- Power cord storage
- Cleaning brush
Important Technical Specifications
- Nominal voltage: 220-240 V ~ 50 Hz
- Rated input power: 200 W
Usage Features
Before the First Use:
Upon receiving the unit, especially after transportation or storage at low temperatures, it should be kept at room temperature for at least three hours before being switched on.
- Unpack the coffee grinder and remove all packaging and advertising materials.
- Ensure that your home mains voltage matches the unit's operating voltage.
- Remove the ground coffee container (1) with its lid (2) by pulling it towards you.
- Remove the coffee bean container lid (7), then turn the container (8) clockwise « » and remove it.
- Remove the upper millstone (9) by turning it clockwise in the « » direction and wipe it.
- Carefully wipe the lower millstone.
- Wash all removable parts (1, 2, 7, 8) with warm water and a neutral detergent, then rinse and dry thoroughly.
- Clean the coffee grinder body (12) with a soft, slightly damp cloth, then wipe it dry.
- Install the upper millstone (9) back into place by turning it counterclockwise in the « » direction until it bumps.
- Install the coffee bean container (8), turn it counterclockwise « » until it bumps, and cover it with the lid (7).
- Close the ground coffee container (1) with the lid (2) and install it into place until the lock (3) clicks.
Using the Coffee Grinder:
The maximum continuous operation time is one grinding cycle, followed by a 3-5 minute break.
- Unwind the power cord completely.
- Ensure that all removable parts are installed properly.
- Open the lid (7) and pour coffee beans into the container (8).
- Note: Do not put more than 250 g of coffee beans into the container (8).
- Cover the container (8) with the lid (7).
- Turn the control knob (11) to select the desired grinding degree:
- «COARSE»: coarse grinding for brewing coffee in a coffee pot.
- «MEDIUM»: medium grinding for drip coffee makers.
- «FINE»: grinding degree for pump-driven coffee makers.
- «EXTRA FINE»: the finest grinding degree for brewing coffee in a cup.
- Note: When selecting the grinding degree, you can set the knob (11) to any position within the scale.
- Insert the power plug into the mains socket.
- Turn the knob (5) to set the desired amount of ground coffee.
- Switch the unit on by pressing the button (6) «U».
- Note: Before switching the unit on, ensure that containers (1 and 8) are installed properly and covered with lids (2 and 7); otherwise, the coffee grinder will not switch on.
- If coffee beans do not reach the millstones during operation, it is recommended to slightly tilt the coffee grinder or shake it carefully.
- The coffee grinder switches off automatically.
- If the coffee bean container (8) becomes empty during operation, or if you need to switch off the coffee grinder immediately, press the ON/OFF button (6) «U» again.
- Unplug the unit after operation.
- For the best taste of the ready drink, grind only the necessary amount of coffee beans right before making coffee.
- To prevent flavor degradation of ground coffee, keep fresh-ground coffee in tightly closed jars or in a vacuum package.
Maintenance Features
Cleaning and Storage:
- Unplug the coffee grinder before cleaning.
- Disassemble the coffee grinder as described in the “BEFORE THE FIRST USE” chapter.
- Wash all removable parts (1, 2, 7, 8) with warm water and a neutral detergent, then rinse and dry thoroughly.
- Do not wash the removable parts in a dishwasher.
- Remove the upper millstone (9) by turning it clockwise « ».
- You can clean the upper and lower millstones with the brush (14).
- Install the upper millstone (9) by turning it counterclockwise « ».
- Wipe the coffee grinder body (12) with a soft, slightly damp cloth, then wipe it dry.
- Use neutral detergents to remove dirt; do not use metal brushes, abrasive or solvents.
- Do not immerse the coffee grinder, the power cord, or the plug into water or any other liquids.
- Do not wash the removable parts in a dishwasher.
- Keep the coffee grinder in a dry, cool place out of reach of children and disabled persons.
Safety Measures
- Read the manual carefully before use and keep it for future reference.
- Use the appliance only for its intended purpose as described in this manual. Improper use may lead to damage or injury.
- Before plugging in, ensure your home mains voltage matches the appliance's operating voltage.
- Do not use the appliance outdoors.
- Use only accessories included in the delivery set.
- Wash all removable parts thoroughly before first use.
- Ensure all parts are properly installed before starting.
- The coffee grinder is intended only for grinding coffee beans.
- Do not switch on the unit if there are no coffee beans in the container.
- The maximum continuous operation time is one grinding cycle; make a 3-5 minute break between grinding cycles.
- If the millstone rotation is hindered, unplug the unit and remove the obstruction.
- Set the grinding degree before switching on the coffee grinder.
- Remove the ground coffee container and open the lid of the coffee bean container only after the unit is switched off and the millstone rotation stops completely.
- Never leave the operating unit unattended.
- Always unplug the unit before cleaning or if you are not using it.
- Do not use the unit near hot surfaces (for instance, gas or electric stove, oven).
- Ensure the power cord does not touch sharp edges of furniture and hot surfaces.
- Do not touch the power plug with wet hands.
- To avoid risk of electric shock and fire, do not immerse the unit, the power cord, or the power plug into water or any other liquids.
- If the unit drops into water:
- Do not touch the water.
- Unplug the unit immediately, and only then take it out of water.
- Apply to the authorized service center for testing or repairing the unit.
- Do not allow children to touch the coffee grinder body and the power cord during operation.
- Do not leave children unattended to prevent using the unit as a toy.
- During operation and breaks between operation cycles, place the unit out of reach of children.
- The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
- For children safety reasons, do not leave polyethylene bags used as packaging unattended.
- ATTENTION! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation!
- Check the power cord and plug periodically. Do not use the coffee grinder if the unit, the power plug, or the power cord is damaged.
- Do not attempt to repair the unit. Do not disassemble the unit by yourself. If any malfunction is detected or after it has dropped, unplug the unit and apply to any authorized service center from the contact address list given in the warranty certificate and on the website www.vitek.ru.
- To avoid damages, transport the unit in the original package only.
- Keep the unit out of reach of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY. ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION AREAS AND WORK SPACES IS PROHIBITED.
Delivery Set
- Coffee grinder assembled – 1 pc.
- Instruction manual – 1 pc.
Guarantee
Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.
This product conforms to the EMC Directive 2014/30/EU and to the Low Voltage Directive 2014/35/EU.
Need help?
General
To Next Page
