13
Inflate the tires to proper pressure.
At this point, your e-bike is a completely functional bicycle, although without any battery
operated to function as yet. Check all tightening points to make sure. Take a short ride.
Adjust the height of the handlebar, and the height and the tilt of the seat, if necessary,
for maximum comfort.
Assembly - Step 3: Charging the Battery
Take out the charger from the box, attached the power cord and insert that to any wall
outlet. Insert the plug at the end of the smaller cable into the charging terminal of the
battery and start charging. The charging terminal is on the side of the battery opposite
to a hole on the side of the frame. The LED on the charger glows RED while charging
and glows GREEN when charging is complete. The battery should be turned OFF while
being charged. When the LED on the charger turns Green, disconnect the charging
cord and cover the charging terminal with the rubber cap. If a battery is installed on the
e-bike and turned ON, the display panel will show the charge level of the battery when
the bike turned ON.
You are now ready to start using your e-bike.
To Next Page
Loading...
