Need help?Do you have a question about the Vitrek 95 Series and is the answer not in the manual?
General| DC Voltage Range | 0 to 6.0 kV |
|---|---|
| Leakage Current Range | 20 mA |
| Insulation Resistance Accuracy | ±(3% of reading) |
| Leakage Current Accuracy | ±(1% of reading) |
| Ramp Time | 0.1 to 999.9 seconds |
| Memory | 100 test steps |
| Interfaces | RS-232, Ethernet |
| Voltage Range | 0 - 5 kVAC, 0 - 6 kVDC |
| Frequency Range | 50 Hz, 60 Hz |
| Display | LCD |
| Operating Temperature | 0°C |
Procedures for manually aborting a test sequence using the STOP button or DIO signals.
Explanation of how the 95x automatically aborts tests due to detected failures or unsafe conditions.
Requirements and considerations for connecting the 95x to a power source.
Step-by-step guide to defining a new test sequence on the front panel.
How to select, prepare, and start an already defined test sequence.
Configuration details for AC voltage tests, including breakdown, arcing, and leakage.
Procedure for performing internal software calibration adjustments to correct tolerances.
Ensuring the device is accurate by performing verification tests with equipment.
To Next Page
