Vitrifrigo D20A - Page 23

23
ENG
From le to right, the temperature levels are the following:
Set 1: 6-8°C - Set 2: 4-6°C - Set 3: 2-4°C - Set 4: 0-2°C
Freezer mode
To start freezer mode, press and hold the corresponding key (C) for one second.
During this mode, it is not possible to change the temperature set. To interrupt freezer
mode, press and hold the corresponding key (C) for one second and the set will go
back to the one set previously.
Night mode
To activate night mode, press and hold the corresponding key (D) for one second.
The 4 LEDs will start to light up alternately from le to right.
During this mode, it is not possible to change the temperature set.
Night mode will stop automatically aer 10h from activation and the set will go
back to the one set previously.
10. EXTRAORDINARY MAINTENANCE AND ASSISTANCE
Cleaning the refrigerator
Before starting to clean the refrigerator, make sure it is not connected to the mains
electricity. If connected, unplug the appliance from the electrical supply.
EXTERNAL - Wash the outside of the refrigerator with lukewarm water, rinse with cold
water and dry with a so cloth. Do not use abrasive or aggressive products.
Cleaning and maintenance of the condenser must be performed only by
authorised aer-sales sta.
INTERNAL - Rinse and carefully dry using a so cloth. Completely avoid the use of abrasive
products, detergents or soaps. in order to avoid the formation of mould or
unpleasant smells, unplug the appliance, empty it and clean the inside and
leave the door half open.
Defrosting the appliance
It will be necessary to defrost the refrigerator every so oen when the frost builds up to a
thickness of more than three millimetres. This operation is necessary in order to guarantee
that the fridge works eciently and to avoid increasing the electricity consumption.
In order to achieve complete defrosting of the refrigerator turn the thermostat control to
the stop position. Keep the drawers open to accelerate defrosting times.
ATTENTION: do not use mechanical devices or other means other than those recommended
by the manufacturer to accelerate the defrosting process.
ATTENTION: do not remove the layer of frost using pointed or sharp metal tools that may
cause a puncture in the cooling plate with irreparable consequences for the appliance.