21ENG
We recommend tting a shut-o valve on the water line. It is possible to make
slight changes to the size of the crescent-shaped ice cubes to arrive at a correct
ice making cycle. To do this, read the section entitled “ACCURATE ADJUSTMENT
WATER SET-UP”.
8. ACCURATE ADJUSTMENT WATER SET-UP
Use a screwdriver on the water level adjustment screw to move the
contact directly on the grid assembly.
• Turn the screw clockwise to reduce the amount of water
• Turn the screw anticlockwise to increase the amount of water
A full turn (360°) will ll with 40 cm³ water (~2.4 sec.)
A half turn (180°) will ll with 20 cm³ water (~1.2 sec.)
9.
HOW TO USE THE ICE MAKER
Il fabbricatore ha due modalità di funzionamento:
• Ice-making mode, where it makes crescent-shaped ice cubes.
• Maintenance mode, where the ice maker does not make any more ice, but simply
stores what it already has.
Ice-Making Mode
While making ice, the machine thermostat needs to be turned to the“ice production”
mode (see g. 1a) to make properly formed crescent-shaped ice cubes.
The ice-making cycle is as follows:
PRODUCTION
The base of the grid assembly is lled with water
and the thermostat remains in the open position.
Once the set temperature has been reached, the cycle for ice ejection from the
grid assembly (~ 40 min.) will begin.
To Next Page
Loading...
