1. The cooker is supplied setup according to the conditions shown on the rating label which is stuck to the rear
of the appliance. From this sticker you can learn for which gas type (LPG or NG) this appliance is
configured when supplied.
2. Power supply voltage of your oven is 220-240V, 50-60 Hz for mono phase and 230V/400V, 50-60 Hz for 3
phases.
3. If the current rate of the fuse in your inst allation is less than 16 Ampere (for mono phase) 32
Ampere (for 3 phase), make a qualified electrician fit a 16 / 32 Ampere fuse.
4. Since the plug of your oven has earth system, ensure using socket with earth system. If it is used without
earth system, our firm is not responsible for any loss which may arise.
5. Keep the gas hose and electrical cable of your oven away from the hot areas; do not let them touch the
appliance. Keep them away from sharp sides and heated surfaces.
6. When the supply cable gets defective, get it replaced by conducting our service as soon as possible.
7. Before changing the oven lamp, disconnect the power plug from the wall socket.
8. Be sure that the cooker is configured correctly for local requirements (for example, the jets must be suitable
for local gas type and gas pressure)
9. Connect your oven to LPG cock in shortest way and without any leakage. Minimum 40 cm - Max. 125 cm
10. When making gas leakage check, never use any flame type like those of lighter, matches, cigarette fire or
similar ones.
11. Usage of your appliance creates moisture and heath in the room it is placed, make sure that your kitchen is
ventilated well.
12. Maintain the natural ventilation ducts properly.
13. When the oven is being used, the reachable parts may be hot, children should be kept off from hot surfaces
and the areas where charged with electricity.
14. When the oven is hot never touch the oven glass by hand or touch by means of a tool.
To Next Page
Loading...