3. INSTALLATION
You can install the Rigid Float very easily. Just put it on your turntable cabinet or an extra
base such as wood block, metal block or anything stable.
(1) Where to put Rigid Float
You can find the best position to put Rigid Float where the trucking error is minimized by
using the template as the way shown below.
Put the stylus on the small hole at the corner of the template sheet and adjust the position
of the pivot where the arm pipe comes over the longer piller of the templete exactly.
* Because of no offset construction, you do not have to care about the distance between
the stylus and the head shell’s connector. By the same token, you can use SPU-A, SPU-G
or EMT without adapter. Instead, adjust the pivot position each time you change
cartridges.
To Next Page
Loading...