(2) Hight adjustment
Adjust the hight of the pivot so as the arm pipe to be horizontal when the stylus is on the
disk. There are 3 ways to adjust the hight of the pivot.
・Changing the hight of the base
・Putting on/off the spike pins
The spike pins can be put on/off easily by finger.
*
You can use any other M3 screws as spikes.
・Changing the hight of the pivot case
Loosen the screw (the pivot case fixation screw) at the side of the pivot base..
Then the pivot case can be slided upwards up to 20mm.
Tighten up the screw after hight adjustment.
To Next Page
Loading...