Nelson Hold
User’s Manual
< Product Concept >
We believe that the most important for cartridge holders (i.e.
headshells) is not only to hold a cartridge but also to support the
magnetic circuit tightly and to suppress the resonance of the cartridge.
To achieve this purpose, the answer we finally reached was to
“Nelson Hold” a cartridge.The “Backbone” supports your cartridge
with the “Bracket” whose surface is 0.1mm behind from that of
the “Backbone”. And, you can press the center of the cartridge
by the “Press Screw”. This leads significant sound improvement
because it is where the magnetic circuit of the cartridge is located.
< How to Use >
Loosen the “Press Screw” until its tip hides from the surface of the “Backbone”.
Then attach the cartridge with the “Cartridge Screw”
to the “Bracket” (choose appropriate type of bracket w/o tapping).
Tighten the both screws evenly. Enjoy the variation of sound
according to the tightening torque of the “Press Screw”.
< CAUTION >
・BE CAREFUL NOT TO BREAK YOUR CARTRIDGE .
・A scar may remain on the cartridge surface.
< Data >
weight : 12.5g!! length : 97mm! lead wire : 4N Silver
To Next Page
Loading...