EasyManua.ls Logo

Viva CHORD - Safety Requirements

Viva CHORD
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The AC adapter is designed exclusively for use with
VIVA electronic instruments. Therefore, do not use
it for other purposes.Only use indoors and non-
humid environments
Position the instrument for easy access to an
electrical outlet. Should a problem or error occur,
immediately turn off the instrument and remove the
AC adapter from the socket. When the AC adapter
is plugged in, small amounts of electricity are
provided at all times, even if the power switch on the
instrument is switched off. Therefore, always unplug
if the device is not to be used for an extended period
of time
Do not place the power cord near heat sources or
radiators. Avoid bending the cord too forcefully or
otherwise damaging it by placing heavy objects on it,
for example.
The instrument must only be connected to the
correct mains voltage.
Use only the supplied adapter, otherwise it may
result in damage to the instrument or overheating.
Never place burning objects, such as candles, on
the instrument, as these may tip over and cause fire.
Always contact your dealer if the power cord is
damaged or you notice unusual odours or smoke
from the instrument. Or if you experience other
problems with the instrument.
SAFETY REQUIREMENTS
PLEASE READ THE INSTRUCTIONS BEFORE USING THE INSTRUMENT
Keep the user guide in a safe place for later use.
AC-adapter
Warning Caution
Follow the safety instructions below to reduce the risk of injury or death
due to electric shock, short circuit, injury, fire or other hazards.
The instrument
cannot
be serviced by the
end
user. Therefore, do not open the instrument or
otherwise attempt to change the interior parts. If the product is not working properly, contact your
dealer or the location where you purchased the instrument immediately.
Do not expose the instrument to rain and do not use it in or near damp or wet areas. Do not place
liquid containers on the instrument. If liquid enters the instrument, immediately turn off the power
and unplug the power.
• Never insert or remove the plug with wet hands.