Vivarium Electronics 2 Series

To Next Page

Vivarium Electronics Series 2 Cage Assembly instructions

1. Congratulations on your new Vivarium

Electronics enclosure. For years of service please

follow the following assembly and use instructions.

First please familiarize yourself with the parts used

to assemble the enclosure and their features.

The cage bottom has a section relieved on the right

underside to aid in under tank heating. Please note

that the recess continues through the cage rear but

is not visible from the front. This will make

orienting this panel easier during assembly

2. The Side Panels are identical with “feet” on the

bottom and stacking recesses on top. The top of

each side panel also has small slots precut front

and rear. These are to allow easy passage of probe

or power cords into the cage.

The Rear Panel has these probe cord/power cord

slots on each end as well as pre-scored potential

openings for larger power cords such as those

used by VE Radiant Heat Panels.

4. During the cage assembly make sure to keep

the panel edges properly aligned and pay

attention that the screws are straight when

screwing the panels together. A little extra time

here will ensure a nice finished assembly.

Need help?

Do you have a question about the Vivarium Electronics 2 Series and is the answer not in the manual?

Summary

Vivarium Electronics Cage Assembly Overview

Bottom, Side, and Rear Panel Features

Details features of bottom, side, and rear panels, including heating relief and cord slots for correct orientation.

Assembly Alignment Best Practices

Guidance on maintaining panel alignment and straight screws during assembly for a quality finish.

Step-by-Step Cage Assembly Process

Attaching Side Panels to Bottom

Instructions for attaching the two side panels to the bottom panel using screws, ensuring flush edges.

Securing Back and Front Panels

Steps for attaching the back panel and then the front panel, including hinge orientation and partial screw placement.

Installing Top Panel and Final Screws

Guidance on placing the top panel, inserting cords, and completing the enclosure assembly by installing remaining screws.