VIVAX EN
20
Clean Heat exchanger
Leave the dryer to cool down.
Residual water may escape, place an absorbent cloth
under the maintenance cover.
1. Unlock the maintenance cover.
2. Completely open maintenace cover.
3. Turn both locking levers towards each other.
4. Pool out the Heat exchanger.
5. Flush the heat exchanger with water to remove lint.
let the water drain properly.
6. Clean the seals.
7. Re-insert the Heat exchanger, the handle at the
buttom!
8. Turn both locking levers.
9. Close the maintenance cover until it locks into
position. Please clean the air condenser approx,
once every 3 months if frequently used.
Do not damage the Heat exchanger!
The fluff and lint accumulated on the filter will block the air
circulation, which will cause the extension of drying time and energy
consumption. Therefore the lint filter shall be cleaned after each use.
Take notice of the correct orientation before to insert the lint filter
Do disconnect the power cord before cleaning!
Do not operate the dryer without the filter!
Clean the filter after each use to prevent lint accumulation inside the
dryer.
Note!
• Clean with water only; do not use hard/sharp-
edged objects! Do not operate the dryer
without the Heat exchanger!
Warning!
To Next Page
Loading...
Need help?
General
