SET UP INSTRUCTIONS
Watch at : bit.ly/mattress8
1. Unfold mattress.
2. Set and position mattress on bed using head and feet icons as guides.
3. Use attached straps to secure mattress to bed.
4. Hang compressor pump over the foot of the bed with the attached hooks.
5. Connect inflation tubes from the mattress to the compressor pump’s
inflating nozzles. Make sure they are properly secured.
6. Connect power cable to pump.
7. Connect compressor pump to electrical outlet.
8. Cover mattress with a bed sheet if desired.
9. Make sure the red CPR valve on the side of the mattress is plugged in
before turning on the compressor pump.
10 . Make sure all connections are secure and push the Power button. The
compressor pump will begin inflating. The mattress will take 50 mins
to inflate.
Note: When the pump starts, the user can adjust the settings according
to the patient’s weight.
11. The compressor pump always displays the air pressure (mmHg) of
the mattress.
12. Hold the “Lock/Unlock Mode” for 3 seconds to unlock panel and
adjust settings.
WHAT’S INCLUDED
• 1x 8” Alternating Pressure Mattress
• 1x Compressor Pump
• 1x Power Cable
• 1x Patching Kit
• 1x Spare Bladder Replacement
• 1-Year Warranty
To Next Page
Loading...