1. When charging the e-bike battery, simply place the bike within reach of the
power supply, connect the charge’s plug to the charging base on the battery,
and then plug in the charger’s power plug to charge.
2. The battery can be installed on the bike for charging, or can be removed
and placed in a convenient place for charging.
3. The red light indicates it is in charging, green light indicates the battery is
fully charged (please put off the plug from the wall). The charging time
depends on the battery capacity, the general charging time is 4-6 hours.
4. Warning: It is forbidden to charge for more than 10 hours, please keep
away from high temperature environment and store in a shade.
6 . Installation Instruction
1. Open the carton, take out the e-bike, and cut the wrapping rope with tools.
2. Handlebar installation:
2.1 Insert the seat tube vertically and align it with the frame head tube. The
depth must exceed the minimum insertion depth marked on the seat tube.
2.2 Align the standpipe so that the handlebar and the frame are at 90
degrees, and then use an M6 hexagon wrench to tighten the mounting screws
on the standpipe.
2.3 Adjust the correct position of the handlebar, and then use tools to lock
the handlebar cover.
2.1 2.2 2.3
3. Headlight installation
3.1 Loosen the headlight screw from the front fork; install the headlight in
the front fork screw hole, and tighten the screw with an Allen tool.
To Next Page
Loading...