Vivint V-SH1 - Update Settings

Smart Hub Setup Guide
- 74 -
Update Settings
Thissectioncontainsinformationaboutthecurrentfirmwareversion,updatesthatareavailable,andsettings
relatedtofirmwareupdates.
descriptions,defaultvalues,andnotesabouttheUpdatesettings.
Toaccessthesesettingsfromthecontrolpanel,goto:
Menu > Settings > Installer Toolbox > Update
FromtheUpdatescreen,youcanviewandconfigurethefollowingsettings.
Current Version
Showstheversionnumberofthefirmwarecurrentlyinstalledonthecontrolpanel'sharddrive.
Broadband Update
Indicateswhetheranupdatetothepanelfirmwareisavailable.Ifanupdateisavailable,pressUpdatetoinitiate
thefirmwareupdateprocess.
NOTE:UsetheSettingsbuttontoenterormodifytheURLpathtowheretheupdateresidesandfromwhereitwill
bedownloadedandinstalled.
IMPORTANT:Thepowersupplyandbackupbatteryshouldbeconnectedtothepanelwhenyouperforma
firmwareupdate.DoNOTattempttopowercyclethepanelwhenanupdateisrunning.