20
4. Use a crescent wrench to secure the outer brackets to the brackets on the wall using
the M8x25 hex bolts and washers. Do not completely tighten the bolts yet! When the
speed dome is installed to the mount pipe, it needs to be swiveled out to the desired
position.
6. Feed cables through the pipe arm. The cable length for passing through the pipe arm is
250cm at least. You can pass a rigid copper wire through the pipe arm rst, and use it to
pull other wires through the pipe.
5. Install the AM-519 adapter to the parapet pipe.
To Next Page
Loading...
