Vivotek IB9365-EHT-A - Page 269

VIVOTEK
User's Manual - 269
© 2019 VIVOTEK INC. All Right Reserved
132
NAME
VALUE
SECURITY
(get/set)
DESCRIPTION
"tampering" = Tamper detection.
"vi" = Virtual input (Manual trigger)
"vadp" = VADP trigger.
"di"= Digital input.
"volalarm" = Audio detection.
"temperature" = Temperature
detection.
"pir" = PIR detection.
"visignal" = Video input signal loss.
"backup" = Backing up recorded files.
"smartsd" = Lifetime detection of SD
card.
"shockalarm" = Shock detection.
"virestore" = Video input signal
restore.
* Only available when [httpversion] >=
0301a
media_num
0,<positive integer>
0/7
Number of media number.
* We support this parameter when
the version number (httpversion) is
equal or greater than 0311c.
storage_dbenabled
<boolean>
0/7
Media files are indexed in database.
protocol_https
< boolean >
0/7
Indicate whether to support HTTP
over SSL.
protocol_rtsp
< boolean >
0/7
Indicate whether to support RTSP.
protocol_sip
<boolean>
0/7
Indicate whether to support SIP.
protocol_maxconn
ection
<positive integer>
0/7
The maximum number of allowed
simultaneous connections.
protocol_maxgenc
onnection
<Not
Recommended to
use this>
<positive integer>
0/7
The maximum general streaming
connections .
* We replaced this parameter with
“capability_protocol_maxconnection”
when the version number
(httpversion) is equal or greater than
0311c.
© 2019 VIVOTEK INC. All Right Reserved
133
NAME VALUE SECURITY
(get/set)
DESCRIPTION
protocol_rtp_multi
cast_scalable
<boolean> 0/7 Indicate whether to support scalable
multicast.
protocol_rtp_multi
cast_backchannel
<boolean> 0/7 Indicate whether to support
backchannel multicast.
protocol_rtp_tcp <boolean> 0/7 Indicate whether to support RTP over
T C P.
protocol_rtp_http <boolean> 0/7 Indicate whether to support RTP over
H T T P.
protocol_spush_mj
peg
<boolean> 0/7 Indicate whether to support server
push MJPEG.
protocol_snmp <boolean> 0/7 Indicate whether to support SNMP.
protocol_ipv6 <boolean> 0/7 Indicate whether to support IPv6.
protocol_pppoe <boolean> 0/7 Indicate whether to support PPPoE.
protocol_ieee8021
x
<boolean> 0/7 Indicate whether to support
IEEE802.1x.
protocol_qos_cos <boolean> 0/7 Indicate whether to support CoS.
protocol_qos_dscp <boolean> 0/7 Indicate whether to support
QoS/DSCP.
protocol_ddns <boolean> 0/7 Indicate whether to support DDNS.
videoin_type 0, 1, 2 0/7 0 => Interlaced CCD
1 => Progressive CCD
2 => CMOS
videoin_nresolutio
n
<positive integer> 0/7 This equals
"capability_videoin_c0_nresolution".
* This is kept for compatibility.
videoin_resolution A list of <WxH>
<product dependent>
0/7 This equals
"capability_videoin_c0_resolution".
* This is kept for compatibility.
videoin_maxframer
ate
A list of <Integer> 0/7 This equals
"capability_videoin_c0_maxframerate
".
* This is kept for compatibility.
videoin_mjpeg_ma A list of <Integer> and 0/7 This equals