Vivotek IB9365-EHT-A - Page 283

VIVOTEK
User's Manual - 283
© 2019 VIVOTEK INC. All Right Reserved
146
PARAMETER
VALUE
SECURITY
(get/set)
DESCRIPTION
privilege
<boolean>
0/7
Indicate whether to support “Manage
Privilege” of PTZ control in the security
page in this video input.
1: support both
/cgi-bin/camctrl/camctrl.cgi and
/cgi-bin/viewer/camctrl.cgi
0: support only
/cgi-bin/viewer/camctrl.cgi
rs485
<boolean>
0/7
An 32-bit integer, each bit can be set
separately as follows:
Bit 0 => support rs485-in
Bit 1 => support rs485-out
buildinpt
<boolean>
0/7
An 32-bit integer, each bit can be set
separately as follows:
Bit 0 => support build-in pan
Bit 1 => support build-in tilt
zoommodule
<boolean>
0/7
Indicate whether to support zoom lens.
In our product, only SD series and IZ
series use the zoom lens.
* Both varifocal and zoom lenses are
built with movable elements that
permit changing the effective focal
length. And the key difference between
a varifocal and a zoom lens can be
explained by thinking about a lens that
has been focused on an object at any
focal length. A varifocal will need to be
refocused whenever the focal length is
adjusted; the zoom will stay in focus
when the focal length is adjusted.
© 2019 VIVOTEK INC. All Right Reserved
147
PARAMETER VALUE SECURITY
(get/set)
DESCRIPTION
focusmode auto,onetimeauto,sp
otlight,manual
<product
dependent>
0/7 Focus mode selection:
"auto": Camera will automatically
adjust the focus position full time to
adapt a clear picture.
"onetimeauto": Camera will
automatically adjust the focus position
one time, which follows any PTZ
control.
"spotlight": Camera will automatically
adjust the focus position full time, and
to consider a spotlight avoidance
situation.
"manual": Turn off the automatically
focus function. For user to control the
focus position manually as their
purpose.
* Only available when
"capability_camctrl_c<0~(n-1)_zoommo
dule" is 1.
* We support this parameter when the
version number (httpversion) is equal or
greater than 0304a.
Group: capability_ptz_c<0~(n-1)> n denotes the value of "capability_nvideoin"
(capability_ptzenabled > 0 and capability_camctrl_c<0~(n-1)>_zoommodule !=0)
* We support this group when the version number (httpversion) is equal or greater than 0303b.
PARAMETER VALUE SECURITY
(get/set)
DESCRIPTION
panspeedlv 0, <positive integer> 0/7 The maximum speed level of pan
motion.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"