Vivotek IB9365-EHT-A - Page 357

VIVOTEK
User's Manual - 357
© 2019 VIVOTEK INC. All Right Reserved
220
NAME
VALUE
SECURITY
(get/set)
DESCRIPTION
enable
<boolean>
6/6
Enable or disable the schedule mode to
control the execution of the VADP
package
begintime
hh:mm
6/6
Begin time of the schedule
endtime
hh:mm
6/6
End time of the schedule
Group: vadp_event
NAME
VALUE
SECURITY
(get/set)
DESCRIPTION
ntrigger
0,<positive
integer>
6/7
Indicate the number of topics to be
transferred to event manager for
trigger.
triggerlist_i<0~(n-1)>_t
opic
string[256]
6/6
Indicate the event notification with this
topic will be transferred to event
manager as trigger.
n is equal to ntrigger above.
7.40 Camera PTZ Control
Group: camctrl (capability_camctrl_ptztunnel > 0)
NAME
VALUE
SECURITY
(get/set)
DESCRIPTION
enableptztunnel
<boolean>
1/4
Enable PTZ tunnel for camera control.
Group: camctrl_c<0~(n-1)> for n channel products (capability_ptzenabled > 0)
n denotes the value of "capability_nvideoin" and k denotes the value of "capability_npreset"
NAME
VALUE
SECURITY
(get/set)
DESCRIPTION
panspeed
-5 ~ 5
1/4
Pan speed
tiltspeed
-5 ~ 5
1/4
Tilt speed
zoomspeed
-5 ~ 5
1/4
Zoom speed
focusspeed
-5 ~ 5
1/4
Auto focus speed
patrolseq
string[120]
1/4
(For external device)
The indexes of patrol points, separated
by “,”
patroldwelling
string[160]
1/4
(For external device)
© 2019 VIVOTEK INC. All Right Reserved
221
NAME VALUE SECURITY
(get/set)
DESCRIPTION
The dwelling time of each patrol point,
separated by “,”
* only available when
capability_camctrl_c0_rs485=2
preset_i<0~(k-1)>_nam
e
string[40] 1/4 Name of the preset location.
preset_i<0~(k-1)>_
dwelling
0 ~ 999 1/4 The dwelling time of each preset
location
* only available when
capability_camctrl_c0_rs485=2
uart 0 ~ "
capability_nuar
t"-1
1/4 Select corresponding uart
(capability_nuart>0).
* only available when
capability_camctrl_c0_rs485=2
cameraid 0~255 1/4 Camera ID controlling external PTZ
camera.
isptz 0 ~ 2 1/4 0: disable PTZ commands.
1: enable PTZ commands with PTZ
driver.
2: enable PTZ commands with UART
tunnel.
* only available when
capability_camctrl_c0_rs485=2
disablemdonptz <boolean> 1/4 Disable motion detection on PTZ
operation.