Vivotek IB9365-EHT-A - Page 397

VIVOTEK
User's Manual - 397
© 2019 VIVOTEK INC. All Right Reserved
260
PARAMETER
VALUE
DESCRIPTION
function
focus,
auto,
scan,
stop,
positioning,
irisopen,
irisenable,
resetfocus,
getstatus
Function type
focus – Move focus motor
auto – Perform auto focus
scan – Perform focus scan
stop – Stop current operation
positioning – Position the motors
resetfocus – reset focus position to default
irisopen – Fully open iris. It will maintain fully open iris
status until sending function=irisenable cgi.
irisenable – return back to user setting status of iris.
getstatus–Information of motors, return value as below:
remote_focus_focus_motor_max: Maximum steps of focus
motor
remote_focus_focus_motor_start: Start point of effective
focal length
remote_focus_focus_motor_end: End point of effective
focal length
remote_focus_focus_motor: Current position of focus
motor
remote_focus_focus_enable: Current function of focus
motor
remote_focus_iris_open: The current status of iris. 0:
irisenable, 1: irisopen
Current function of zoom/focus motor, return value as
below:
0: no service
1: zooming
2. focusing
3: auto focus
4: focus scan
5: positioning (both zoom motor and focus motor)
12: reset focus
direction
direct,
forward,
backward
Motor’s moving direction.
It works only if function= focus.
© 2019 VIVOTEK INC. All Right Reserved
261
PARAMETER VALUE DESCRIPTION
position 0~<motor_max> Motor’s position.
It works only if function=focus and direction=direct.
<motor_max> is refer to remote_focus_focus_motor_max
which replied from "function=getstatus"
steps 1 ~ <motor_max> Motor’s moving steps.
It works only if function=focus and direction=forward or
direction=backward.
<motor_max> is refer to remote_focus_focus_motor_max
which replied from "function=getstatus"
* This parameter is for additional fine-tune, the value is from 1 to 30.
iris N/A Open iris or not.
It works only if function=auto or function=scan.
8.21 Export Files
Note: This request requires Administrator privileges.
Method: GET
Syntax:
For daylight saving time configuration file:
http://<servername>/cgi-bin/admin/exportDst.cgi
For language file:
http://<servername>/cgi-bin/admin/export_language.cgi?currentlanguage=<value>
PARAMETER VALUE DESCRIPTION
currentlanguage 0~20 Available language lists.
Please refer to:
system_info_language_i0 ~ system_info_language_i19
.
For setting backup file:
http://<servername>/cgi-bin/admin/export_backup.cgi?backup