Vivotek IB9365-EHT - Page 202

VIVOTEK
202 - User's Manual
s<0~(m-1)>_m
jpeg_bitrate
20000~"capability_videoin_c<0~(n-1
)>_mjpeg_maxbitrate"
4/4 The target bit rate in constant bit rate
mode.
* Only valid when "ratecontrolmode"=
cbr
s<0~(m-1)>_m
jpeg_prioritypoli
cy
framerate,imagequality 4/4 Set prioritypolicy
* Only valid when "ratecontrolmode"=
cbr
s<0~(m-1)>_m
jpeg_maxframe
1~"capability_videoin_c<0~(n-1)>_
mjpeg_maxframerate"
1/4 The maximum frame rates of a mjpeg
stream at different
resolutions("capability_videoin_c<0~
(n-1)>_resolution") are recorded in
"capability_videoin_c<0~(n-1)>_mjp
eg_maxframerate"
s<0~(m-1)>_ra
tiocorrect
<boolean> 1/4 Change resolution to fit 4:3 ratio.
For PAL:
D1/4CIF(720/704x576) -> (768x576)
CIF(352x288)->(384x288)
For NTSC:
D1/4CIF(720/704x480) -> (640x480)
CIF(352x240)->(320x240)
* Only available when
capability_videoin_type is 0 or 1.
wdrpro_mode
<product
dependent>
<boolean> 4/4 Enable WDR pro
* Only available when
"capability_image_c<0~(n-1)>_wdrp
ro_mode" > 0
wdrpro_strengt
h
<product
dependent>
1~100 4/4 The strength of WDR Pro.
The bigger value means the stronger
strength of WDR Pro.
* Only available when
"capability_image_c<0~(n-1)>_wdrp
ro_strength" is 1
wdrc_mode
<product
dependent>
<boolean> 4/4 Enable WDR enhanced.
* Only available when
"capability_image_c<0~(n-1)>_wdrc
_mode" is 1
wdrc_strength 1~100 4/4 The strength of WDR enhanced.