VIVOTEK
User's Manual - 117
■ Refresh: Click this button to refresh all current connections.
■ Add to deny list: You can select entries from the Connection Status list and add them to the
Deny List to deny access. Please note that those checked connections will only be disconnected
temporarily and will automatically try to re-link again (IE Explore or Quick Time Player). If you
want to enable the denied list, please check
Enable access list ltering
and click
Save
in the
rst column.
■ Disconnect: If you want to break off the current connections, please select them and click this
button. Please note that those checked connections will only be disconnected temporarily and
will automatically try to re-link again (IE Explore or Quick Time Player).
Filter
Enable access list ltering: Check this item and click
Save
if you want to enable the access list
ltering function.
Filter type: Select
Allow
or
Deny
as the lter type. If you choose
Allow Type
, only those clients
whose IP addresses are on the Access List below can access the Network Camera, and the others
cannot. On the contrary, if you choose
Deny Type
, those clients whose IP addresses are on the
Access List below will not be allowed to access the Network Camera, and the others can.
Then you can
Add
a rule to the following Access List. Please note that the IPv6 access list column
will not be displayed unless you enable IPv6 on the Network page. For more information about
IPv6 Settings
, please refer to Network > General settings on page 87 for detailed information.
To Next Page
Loading...
Need help?
General
