Vivotek IB9387 Series User Manual

VIVOTEK
12 - User's Manual
9. Use the alignment sticker to drill mounting holes on the wall. If preferred, drill a routing
hole. Install the camera by hammer in the wall anchors and drive screws.
5.5 ~ 6.5mm
8. Pass an Ethernet cable through the waterproof cable gland components, and through the
rubber seal as shown below. Connect the Ethernet cable to the camera's RJ45 onnector.

Vivotek IB9387 Series Specifications

General

Brand	Vivotek
Model	IB9387 Series
Category	Security Camera
Language	English