7.10 IR cut control
Group: ircutcontrol
NAME VALUE SECURITY
(get/set)
DESCRIPTION
mode auto,
day,
night,
di,
schedule
6/6 Set IR cut control mode
daymodebegintime 00:00~23:59 6/6 Day mode begin time
daymodeendtime 00:00~23:59 6/6 Day mod end time
disableirled <boolean> 6/6 Enable/disable IR led
bwmode <boolean> 6/6 Switch to B/W in night mode if enabled
sensitivity low,
normal,
high
6/6 Sensitivity of light sensor
7.11 image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VALUE SECURITY
(get/set)
DESCRIPTION
brightness -5 ~ 5 4/4 Adjust brightness of image according to mode settings.
saturation -5 ~ 5 4/4 Adjust saturation of image according to mode settings.
contrast -5 ~ 5 4/4 Adjust contrast of image according to mode settings.
sharpness -3 ~ 3 4/4 Adjust sharpness of image according to mode settings.
mode preview,
restore,
save
7/4 Preview => Apply the parameters of image without saving.
Restore => Restore the previous saved image parameters.
Save => Directly save the adjust image parameters.
7.12 image setting for preview
Group: imagepreview_c<0~(n-1)> for n channel products
NAME VALUE SECURITY
(get/set)
DESCRIPTION
brightness -5 ~ 5 4/4 Preview of brightness adjustment of image
according to mode settings.
saturation -5 ~ 5 4/4 Preview of saturation adjustment of image
To Next Page
Loading...
