EN - 10
1. Check the SSID for your wireless access point (AP).
2. Go to the PZ8111W/21W's Conguration page > Advanced mode > Wireless LAN.
3. Type in the SSID the same as your AP.
4. Select the Wireless mode as "Infrastructure".
5. Click Save. The Network Camera will reboot.
Note
1. SSID, abbreviated from Service Set Identier, is the name assigned to the wireless
network. The PZ8111W/21W factory SSID setting is set to "default".
2. Select "Ad-Hoc" wireless mode if you want the PZ8111W/21W to communicate without
using an AP or wireless router.
e e
POWER
COLLISION
LINK
RECEIVE
PARTITION
1
2
3
4
5
ADSL/Cable/Hub
AP
AV Out
For further setup, please refer to the user's manual on the software CD.
Congure the Wireless Connection
(PZ8111W/21W only)
7
PZ8111W/21W
6. Wait for the live image to be reloaded to your browser. Then, unplug the power cable and
Ethernet cable from the Network Camera.
7. Replug the power cable to the camera. The Network Camera will now operate in wireless
mode.
To Next Page
Loading...
Need help?
General
