Step 4 — Optional Drain to waste
• If the drip tray is connected to the drain hose, the blind plug must be removed. (see rst picture)
• To connect the hose to the drip tray, the water dispenser must be tilted slightly to the side. (see
second photo)
• Please note: The hose must be pulled without hose clamp, untreated and dry on the drip tray,
otherwise it will slide down again!
• Remove the foil from the drip tray grid. (third picture)
• Check whether the water is draining correctly from the drip tray
If no drain is available skip to step 6
Step 5 — Secure connections to the device
• Tilt the device to get to the connections below and to connect them.
• An angle is provided in the installkit. Otherwise, the device cannot be moved.
• At this point the screw feet should be removed and disgarded.
• If the device is mounted on the base cabinet, follow the instructions starting on page 18.
To Next Page
Loading...
