Need help?Do you have a question about the Vivreau Top Pro and is the answer not in the manual?
Unpack the device and check the installation kit and accessories for completeness.
Check the installation site for necessary pre-requirements like water supply and power outlet.
Understand the water connection scheme and connect components as per the diagram.
Connect the drip tray to the drain hose if a drain is available.
Tilt the device to access and connect all necessary hoses and cables.
Open the device housing and perform a check for possible leaks.
Remove sidewalls and loosen the cover by following specific screw and latch instructions.
Install side panels by inserting into sealing lips and fastening with screws.
Information regarding the SX3 hygiene filter for devices with the Hygiene Plus option.
Instructions for carrying out chemical cleaning of the device via the menu.
Prepare for dry cleaning, ensuring safety and proper setup before starting the program.
Initiate the integrated cleaning program through the service menu and admin mode.
Insert new SX3 filter and add specified cleaning agent to the service cartridge.
Insert, rinse, and use the service cartridge with cleaning agent during the process.
Rinse the device with detergent and empty the carbonator as per instructions.
Rinse the system thoroughly to remove residual cleaning solution.
Set the flow pattern on the compensator if the water flow is too fast or too slow.
Adjust sparkling and still water flow rates using the upper and lower adjusting screws.
Set compensator and needle valve to basic parameters for optimal spray pattern.
Remove protective films, adjust portioning with customer, and hand over the device.
Unpack the base cabinet, verify assembly material, and check for transport damage.
Remove mounting flaps from the base cabinet for installation access.
Securely fasten the base cabinet to the wall or place it freely using the base plate.
Mount the main device onto the base cabinet, connecting hoses and securing with screws.
Mount Aquastop, pressure reducer, filter head, and CO2 bottle within the base cabinet.
General| Material | Stainless Steel |
|---|---|
| Power Supply | 220-240V |
| Voltage | 220-240V |
| Frequency | 50/60 Hz |
| Type | Countertop |
| Temperature Range (Heating) | Up to 95°C |
| Filter Life | Approximately 6 months |
To Next Page
