VIZIT-КТМ600F
OPERATING INSTRUCTION
VIZIT-KTM600
KTM600
RF ontroller is intended for access control in auxiliary, industrial and inhabited buildings and
premises and is able to control either electromagnetic or electromechanical lock. ontroller con eader
and ontrol nit and may be used as part of doorphone as well as stand-alone system.
C
, The RF c tains R
CU a
F
RD-4F
M,
Only VIZIT-RF VIZIT-RF keys ( ) are supported3.x or 4.x 13.56 MHz .
ML EL
PRG
1S
7S
(1) Power LED
(2) ’sReader antenna
1
2
Destination
Wire colour
Supply voltage for RD-4FRed
GroundBlack
DataWhite
Supply voltage for Reader’s
buzzer
Blue
3
Reader RD-4F appearance, destination of wires
(3) Connecting wires
(1) Holes for screws
(2)
(3) Control Unit’s PCB
(4) Terminals to connect to power supply unit, Reader RD-4F, EXIT button and lock
Holder for fixing the Control Unit on a DIN-rail
Control Unit KTM-600M appearance
Destination
Terminal
Door lock control
-DL
+DL
Supply voltage for
Control Unit and Lock
+E
Supply voltage for
Reader’s buzzer
BIP
Ground
RD
Data
RG
Сontrol command OPEN
from EXIT button or
doorstation
OP
Ground
GND
1
2
3
4
Control Unit without the cover
www. 5VIZIT-KTM600F Operating Instruction (revision 10)vizit-group.com 1 11/201 -
To Next Page
Need help?
General
