RF ontroller is intended for access control in auxiliary, industrial and inhabited buildings and
premises and is able to control either electromagnetic or electromechanical lock. ontroller con reader
and control unit and may be used as part of doorphone as well as stand-alone system.
.
Entrance door unlocking ACCESS keys
Entrance door unlocking by pressing the indoor EXIT button
Guard mode can be enabled disabled with a GUARD
or MASTER key All ACCESS keys are disabled in this mode
Programmable unlocked state duration
Light sound indication of operating modes
MASTER key memorizing
GUARD ACCESS keys memorizing and erasing
All data erasing
RF- keys, lock and EXIT button are available upon request.
.
.
.
C
, RF c tains the
the a
with (up to 2680 keys)
or key (up to 28 keys)
the - (1 key).
1 s or 7 s
and
-
and
300M
The product does not contain voltage above
Do not make any connections or repair when the power is on
Take care not to spill any liquids or chemically active substances on the product. Switch the power off before cleaning the
product. Clean by wiping with dry soft cloth. Do not use any liquid cleaners, aerosol cleaners or abrasive agents
VIZIT-KTM600R
KTM600
Only VIZIT-RF2 keys (125 KHz ) are supported
FEATURES
PARTS LIST
SAFETY INSTRUCTIONS
2
RD-3
M,
4 VDC
·
·
·
·
·
·
·
·
Operating Instruction
x1
x1x1
Control unit KTM600M Reader RD-3
Fasteners
Screw 3.5 25-х
Anchor - 6х30
for control unit KTM600M
x2 x2
for reader RD-3
Screw 3.5 3-х0
x2 x2
Gag
x 4
Anchor - 6х30
www.vizit.eu VIZIT-КТМ600ROPERATING INSTRUCTION
1/6
VIZIT-КТМ600R
OPERATING INSTRUCTION
To Next Page
Need help?
General
