ViziT KTM600R - Page 3

300M shall be the entrance doorway , or on
may s
If you use an electro-mechanical lock, connect for example 1N4007, not supplied directly the ’s
Use copper wires for connections with regard to the acceptable cross-sections and lengths shown in the below table:
To ensure proper operation, total c ance s r and c u must
perform the control unit’s setup. R on the PCB
The determines logic and should comply with the lock type used
, across its terminals
, across its terminals
The determines -
To ensure door unlocking from the inside, the EXIT button installed inside near
the door. Any button with NO contacts be used as well. See the example of connection diagram on Fig. .
a damper diode ( ) to lock
terminals (see Figure ).
* apacit of cable connecting the eader ontrol nit not exceed 2500 pF.
, emove the lid and set jumpers according to
the table:
jumper lock control :
Set the jumper to position in case of an electromagnetic lock.
The lock will release when voltage is off.
Set the jumper to position in case of an electromechanical lock.
The lock will release when voltage is on.
jumper unlocked state duration 1 or 7 seconds.
12
WARNING. unit
IMPORTANT.
DO NOT use electromagnetic locks with impedance less than 20 Ohms and not provided with a
2
,
Do not mount the power supply near heating equipment!
built-in
degaussing module.
LOCK
ML
EL
TIME
Before turning the power on
-
-
unit 19w/14.4v/EU (12V/1.5A) may
heated ,
To provide power for , the power supply BPD18/12-1-1 or be used. It
should be installed in a place with proper ventilation and fixed on a wall or a DIN-rail.
VIZIT-KTM600R
Circuit
Wire
Maximum length, m
0 3.
Diameter, mm
0 07.
Cross-section, mm
2
0 2.0 5.
0 5.0 8.
Control Unit « Reader
Control Unit « Button for exit
10
10
30
50*
5
25
25
50*
50
50
50*
50
BPD ontrol Unit« C « Electromagnetic lock
BPD ontrol Unit« C « Electromechanical lock
Lock Type
Jumper
Electromagnetic
Figure()
VIZIT-ML400
1
Electromechanical
Figure()
EL-301B
2
LOCK
ML
EL
TIME
7s
1s
ML
EL
PRG
1S 7S
www.vizit.eu VIZIT-КТМ600R
3/6
OPERATING INSTRUCTION