Sum distance: can make the total driving distance same as dashboard(if the
dashboard shows the sum distance is 30010Km,the user can make the device
value at 30010KM)
Power off time:default power off time is 10s,for Auto start and stop
cars,please make the power off time to 180-240s
Sleep Voltage:default is off ,if the device can’t auto off,please adjust the
voltage at 13.2V or higher
Clock Set:adjust the device time as your local time
HUD Mode Set: the default is off, you can turn on to reflection on the
windshield
Progress bar function switch: default LHK is fuel consumption progress
bar,can switch to RPM bar
Factory set: find the factory set selection,short press in to do the factory set
OBD diagnose set
Scan DTCs: scan the ECU to check if there is the error code,and show the
error details
Clean DTCs: switch to Clean the DTCs,short press in the button to finish the
cleaning
Driving test
Speedup test: show the speed,distance,driving 400m takes time,driving 100m
takes time
Brake Test:show the speed,brake distance and time
Data Stream
Show all the vehicle data stream
OBD smart digital device installation :
1.Know your vehicle brand,the OBD smart digital device work for cars with
OBDII agreement or EU OBD agreement. Open the engine hood and find the
sticker below it (see the below picture 1), if it has words like OBDII
CERTIFIED, then it can be installed.
2.Find out the 16 pin diagnostic link (see the below picture 2) of the vehicle
and connect it well with OBDII connecting line.
To Next Page
Loading...