Vlectro OP 011954 - Specifications

6
EN
Please read the instruction carefully before installation and use.
Specifications
Receiver: 4 x AAA baeries (not
included)
Baery (transmier): 12V 23A
(included)
Range: Up to 150m
Sound level: 0 - 100dB, 4 levels (mute
included)
Transmission frequency:
433Mhz±0.5Mhz
Accessories
Transmier
Receiver
12V 23A baery
Mounting screws
Double-sided tape
Installation
You can install the transmier with either double-sided tape or screws:
1. To mount with screws, open the transmier with a screwdriver. Penetrate the two holes
at the back cover with two screws. Then fix the screws on the wall at a suitable height.
Mounting on UPVC or metal doorframe surfaces will reduce the transmiing range.
To install using screws you will require a drill and cross-headed screwdriver.
IMPORTANT: Prior to drilling any holes into the wall, ensure that there are no cables or
pipes present that may be inadvertently damaged.
2. Use the double-sided adhesive tape to fix the transmier on the wall.
Receiver
Insert 4 x AAA baeries into the baery compartment, please note the correct baery
polarity.
Doorbell
Press the buon on the transmier once to send a wireless signal to the receiver which
will then chime. Holding the buon will not repeat the sound.
Melody
Press the music buon to change the doorbell melody, Press and hold the music buon for
3 seconds to reset the melody.
Important
1. The receiver is only for use indoors.
2. Don't aach the transmier to a metal surface or a UPVC doorframe, as this will lessen
its operation range.
3. Avoid exposing the receiver to water or submerging any of the units in water.
4. Do not install either device near a fireplace or subject it to high temperatures.
5. If you're not using the doorbell for a long time, remove the baery from both the
transmier and the receiver
6. Dispose of the old baery in accordance with the applicable laws.