In case the engine does not start, try to
restart it without insisting too much in
order not to damage the starter motor.
If the problem persists, contact a techni-
cal assistance centre that is authorised
by the manufacturer.
11-Stop the motor when you finish this op-
eration.
Follow the procedure below.
1- Start the engine and run it at minimum
speed for a few minutes.
2-Run the engine at normal speed until the
operating temperature (70÷80°C) is
reached.
3-Turn off the engine and let it cool down.
4-Make sure the fixing screws of the main
parts are tightened properly.
5-Check the union sealing on the fuel sup-
ply circuit.
6-Check the tightening of the clamps.
7-Check any fluid leaks.
CONTROL SCREW TIGHTENING AND UNION SEALING
Follow the procedure below.
1- Start the engine and bring it to the
operating temperature (70÷80 °C).
2-Turn off the engine and remove
the ignition key.
3-Place the engine on a perfectly
level surface.
4-Wait a few minutes so that all
the oil will flow into the sump.
5-Remove the dipstick (L) and
check the oil level.
6-Top up, if necessary, from plug
(M). When topping up the oil, to
avoid exceeding the maximum allowed val-
ue, add the oil in small amounts (100 to 200
ml at a time) until it reaches the correct level.
To Next Page
Loading...
Need help?
General