Scooter Cockpit Introduction
The VoroMotors TFT display is controlled by the rubber button console on top of the
handlebars. There is an M (Mode) button, directional (+/-) buttons, and a power
button. This is the main button console that powers on the scooter.
The headlight, turn signals and horn are controlled by the rubber button console
facing the seat. There are green indicator lights beneath the left and right buttons to
remind you the signals are engaged. The taillight includes LEDs that act as both the
turn signals and brake light. Please keep in mind that when the brakes are applied,
turn signals will not also respond (e.g., only brake light or turn signals will display).
The Domino twist grip throttle is mounted on the right handlebar and is
cable-operated. The throttle is the full width of the handgrip, which you twist to
accelerate. The brake lever on the left engages the rear hydraulic brakes; the lever
on the right engages the front hydraulic brakes.
Adjustable handlebar height: The RoadRunner Pro has a unique stem adapter with
height rings, that allow you to set the handlebars slightly higher or lower. To make the
handlebars lower, remove the rings. To keep the handlebars at their tallest height,
keep all rings installed.
Distributed by and property of VoroMotors 3
To Next Page
Loading...