Need help?Do you have a question about the VMP FRM Series and is the answer not in the manual?
Before starting, lay out all parts and verify them against the provided parts list for assembly.
Assemble the stand bars to create two wells using short screws, lock washers, and nuts.
Attach the support tube in the center of the middle stand bars using a long screw, washer, and nut.
Connect two arms to stand bars using short screws and to the support tube using long screws.
Connect two arms to stand bars using short screws and to the support tube using long screws.
Load ballast (weight) into the sled to weigh down the non-penetrating mount as required for the application.
It is highly recommended that the installation of this mount be done by a professional.
Installer must verify correct ballast amount, roof structure strength, and adherence to codes and standards.
General| Brand | VMP |
|---|---|
| Model | FRM Series |
| Category | Racks & Stands |
| Language | English |
To Next Page