VnetPhone Riders V6 - User Manual

INTERPHONE INSTRUCTIONS
There are only four buttons that you need to consider (Volume + and -,
Reset/Off and the Interphone button).
To turn on and connect two (V6) units:
Start with both V6 units turned off. (Press the RESET button to turn off)
On both units simultaneously, press and hold the INTERPHONE button until the
LED flashes red and blue continuously. Release the INTERPHONE buttons
when you see both units flashing red and blue.
On the first unit, press the INTERPHONE button. The LED will flash blue as it
seeks to pair with the other. Wait for 5-10 seconds, after which time the LED
on the other unit should also start to flash blue.
Press the INTERPHONE button again on the first unit to set the communication
channel between the two units.
Adjust the volume (+/-) as necessary
When finished, turn off the units by pressing the RESET/OFF button
If you press one of the other buttons during a match, you may lose the
communication channel between the two units, although the connection should
still remain. You should be able to recover communication by either pressing
the INTERPHONE button again, or by pressing the green telephone button (if
that was the one that was pressed)
Volume +
Volume -
Reset / Off
Interphone
button

Summary

Interphone Instructions Overview

Connecting Two (V6) Units

Steps to turn on, pair, and set communication channel for two V6 units.

Volume Adjustment and Power Off

Instructions on how to adjust volume and turn off the units using the RESET/OFF button.

Interruption and Recovery

What happens if other buttons are pressed during a match and how to recover communication.

Headset Connections

Jabra Wave Headset

How to connect the Jabra Wave headset using the 3.5mm audio socket and adapter cable.

Acoustic Air Tube Earpiece

Connecting the acoustic air tube earpiece with an adapter for use with the interphone.

Interphone Charging

Charging Procedure and Battery Care

Guidance on charging the interphone, charging time, LED indicators, and battery care for long periods.

Connecting Three Units (Coach V4)

Resetting Existing Pairings

How to reset all previous pairings on the V4 coach unit before establishing new connections.

Connecting the First Pair (V4 to V6)

Steps to pair the V4 coach unit with the first V6 unit, involving button presses and LED indicators.

Connecting the Third Unit

Procedure to connect the third unit to the V4 coach unit, involving specific button presses.

Enabling Three-Way Connection

Final step to enable three-way talk and listen by pressing a specific button on the V4 unit.

VnetPhone Riders V6 Specifications

General

Brand	VnetPhone
Model	Riders V6
Category	Intercom System
Language	English