T5 Combination Charger Wall Mount
This unit provides a convenient surface for mounting the T5 10-Bay Combination Charger and
its associated power supply on a wall.
Product notes
• Customer assembly required.
Be aware of potential hazards (electrical wires, waterlines, etc.) when drilling the pilot
holes. Customer assumes all responsibility for the installation of these units. A terminal
charger cannot have another charger placed directly above it. A section of dry-erase board
(included) must be placed above each terminal charger.
• If you drill into a wall stud when drilling a pilot hole for one of the anchors, do not use an
anchor with that hole.
• The lowest anchor for each extrusion must be a minimum of 12 inches from the floor.
• Be aware of the location of your power outlets and other receptacles when mounting the
extrusions. When the unit is fully assembled, you will not have access to the area behind
the chargers.
Procedures
Follow these procedures to install the T5 Charger Wall Mount.
Mounting the Bracket
Parts list (Included) Note that the item numbers correspond to the numbers in image 1.
Item
#
Quantity Description
1 1 Mounting Bracket
2 4 Self-drilling screw anchor #10
3 4 Washer, #10, flat, type B regular
4 4 Screw, #10 Phillips pan head
Tools and Equipment Needed
• Tape or push pins
• Drill with 1/8” bit
• Level
• Screwdriver, #2 Phillips
• Drilling template sheet (included)
1. Using tape or push pins, fasten the drilling template sheet to the wall. Make sure that
the bottom anchor holes on the template are at least 12 inches from the floor and,
using the level, make sure that the sides of the template are vertical.
2. Using the template as your guide, mark four holes for the anchors. Be aware that there
are two sets of pilot markers; one set for wall studs with 12 inch centers and one set
for wall studs with 16 inch centers.
To Next Page
Loading...