3. Remove the template from the wall.
4. Drill the pilot holes for the anchors.
5. Insert the anchors into the pilot holes by screwing them into place.
6. Place the bracket against the wall and align its holes with the anchors that were
installed in step 5. Position the bracket so that its flat side is against the wall and the
mounting pins are away from the wall.
7. Place a washer over one of the screws and insert the screw through the hole in the
bracket and into the anchor. Tighten the screw part way so that it holds the bracket in
place; do not completely tighten the screw. Repeat this step with the other screws and
washers.
8. Secure the bracket by completely tightening the screws.
9. Tilt the Combination Charger back and slide it onto the wall by lining up the tabs on
the top of the bracket with the notches in the back of the Combination Charger. Level
the charger so the supports on the bottom of the bracket are underneath the charger
(see image 1).
Image 1
Vocollect part number
Mounting Bracket for 10-Bay T5 Combination Charger #CM-701-1
To Next Page
Loading...