Putting a Terminal on a Belt or
Shoulder Harness
Using the T-Series Belts and Clips
To mount a terminal onto the specially designed belt or shoulder harness, an operator must
have a slim belt clip (provided with the belt or harness). The clip should be attached to the
belt at the beginning of a shift. Then, the operator can attach the terminal to and remove the
terminal from the clip as often as necessary.
Notes: Vocollect strongly recommends that the terminal be worn on the right side of the
body with the terminal's buttons on the top and its connectors toward your back.
T5 belt clips are black.
T5 terminals can be worn on a belt or shoulder harness.
To put the clip on a belt:
Note: The terminal is properly clipped in place if you cannot remove it from the clip
without pressing the terminal's clip release button.
To Next Page
Loading...