Using a T5 10-Bay Combination
Charger
T5 terminals should be placed into a charger when not in use. The charger serves as a link to
the host computer so that new tasks can be downloaded, terminal settings can be
reconfigured, and terminal software can be updated. The charger also charges the battery that
is currently connected to the terminal.
Notes:
• A terminal is always on when it is in a terminal charger. When a terminal that is
powered off is placed into a terminal charger, it automatically turns on and its LED
indicator eventually begins to blink green.
• A terminal should not be placed into a terminal charger without a battery
attached to it. Do not remove the battery from the terminal when placing the
terminal into a charger.
• For the T5 terminal, the T5 Charger provides the capacity to charge batteries
(attached to or separate from terminals) and to store terminals. See Charging a
Battery: T5.
To place a terminal into a terminal charger, perform the following steps:
1. Make sure the charger is powered. The charger's orange power light (LED indicator) is lit
when the
charger is powered.
2. If you sign on and sign off terminals at your site, sign off the terminal.
3. Press and hold the yellow play/pause button until the LED indicator turns solid red and
then turns off.
Note: It is not absolutely necessary to turn the terminal off before placing it into the
charger.
4. Remove the terminal from the belt clip.
5. Disconnect any other peripherals.
6. Insert the terminal into one of the terminal charger slots with the button controls of the
terminal to the top and facing toward the left.
To Next Page
Loading...