Need help?Do you have a question about the VocoPro DA-1055 PRO and is the answer not in the manual?
Explains how to connect audio from source players using RCA cables.
Explains how to connect video from source players using RCA cables.
Describes connecting audio outputs (MIX 1/2, LINE OUT) to mixers or amplifiers.
Explains how to connect video outputs to TV monitors using RCA cables.
Details connecting wired and wireless microphones to front and rear jacks.
Covers powering on the unit, EQ channels, vocal cancel, and input selection.
Explains how to adjust volume for each mic pair independently.
Provides solutions for common problems like no sound, distorted vocals, or echo issues.
General| Channels | 2 |
|---|---|
| Bands | 10 |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 10k Ohms |
| Output Impedance | 600 Ohms |
| Signal to Noise Ratio | >90dB |
| Boost/Cut Range | +/- 12dB |
| Type | Stereo |
| Input Sensitivity | 0.775V |
| Power Supply | 110V/220V |
| Dimensions | 19" x 1.75" |
To Next Page