EasyManua.ls Logo

Volantex ASW 28 User Manual

Volantex ASW 28
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
instruction manual
...our glider...
This model is best suited for slope flying and aero tow, but will do well on a good thermal day. Due to its high aspect ratio, the ASW-28
will cover a lot of ground, but due to it's low wing loading, it has very smooth handling.
This medium sized 4m version of the ASW-28 can open up new soaring areas on slopes too small for large scale birds, but still give that
"Bigger is Better" feeling in the air.
...you will receive the...
The kit comes completely finished. The wings are finished and covered, spoilers installed and the ailerons are hinged, the
winglets are fiberglass molded. The clear plastic canopy is fitted to the fiberglass tray, wing joiner system is installed in the
fuselage. All what's required is your radio gear. You will need 4 micro servos fro the ailerons and airbrakes, two regular
servo for the rudder and elevator.
www.top-modeltehnik.com , info@topmodeltehnik.com
WARRANTY
TOP modeltehnik ltd Model Manufacturing guarantees this kit to be free from defects in both material and workmanship at the date of purchase.
This warranty does not cover any component parts damaged by use, modification or tranposrt.
Further, TOP modeltehnik ltd reserves the right to change or modify this warranty without notice.
In that TOP modeltehnik ltd has no control over the final assembly or material used for final assembly, no liability shall be assumed nor
accepted for any damage resulting from the use by the user of the final user-assembled product. By the act of using the user-assembled
product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to return this kit
immediately in new and unused condition to the place of purchase.
ARF
STYRO OBECHI wings
Wing Span:
Length:
Wing Area:
Wing Airfoil:
Loading:
Flying Weight:
RC functions:
4.0m
1.75m
76 dm2 HQ 3/15 - HQ
3/10
72 g/dm2
5.5 kg (88 oz)
elevator, ruder, ailerons,
airbrakes, retract
Question and Answer IconNeed help?

Do you have a question about the Volantex ASW 28 and is the answer not in the manual?

Volantex ASW 28 Specifications

General IconGeneral
Length1132 mm
MaterialEPO Foam
ESC40A Brushless
Recommended Receiver6CH
MotorBrushless 4023/850KV
Servos9g *6pcs
Control System4-channel (Aileron, Elevator, Rudder, Throttle)

Summary

WARRANTY

INTRODUCTION

IMPORTANT SAFETY PRECAUTIONS

Crucial safety measures for handling, assembly, and operation of the model to prevent injury or damage.

Accesoriess Needed

Lists essential radio equipment, servos, batteries, and tools required for the model's operation and assembly.

Replacment parts

KIT CONTENTS

ASSEMBLE THE FUSELAGE

Mount the Elevator

Instructions for attaching the elevator control horn and stabilizer to the fuselage using bolts and nylon backplates.

Mount the Servos in the fuselage

Details on gluing servo tray doublers and mounting servos within the fuselage for elevator and rudder control.

Install the Elevator and Rudder Pushrods

Install the Receiver and Battery

BALANCE THE MODEL

Set the control throws

Guidance on accurately measuring and setting control surface throws for optimal flight performance and stability.