Volcano SOLID VALVE User Manual

2. Choose temperature 3. Grind substance 4. Fill Filling Chamber
max. 10 mm
min. 1 mm
max. 1/2 inch
min. 1/16 inch
5. Insert Filling Chamber Insert
approx. 5 sec.
6. Preheat substance
if control lamp is off
7. “Click” Valve Balloon
on Filling Chamber
ok
8.
Watch vapor density
9. Remove full Balloon Unit 10. Detach Valve Balloon
from Filling Chamber
11. Caution! Hot surface!
Never leave Filling Chamber
on VOLCANO
12. “Click” Mouthpiece
on Valve Balloon
1. Switch heat on
(takes 3-5 min.)
www.storz-bickel.com
Quick Start Manual for
STORZ & BICKEL GMBH & CO. KG · In Grubenäcker 5-9 · 78532 Tuttlingen/Germany
Refer to the Instructions for Use for important safety and user advice. Do not operate the device without rst reading and understanding the Instructions for Use!

Volcano SOLID VALVE Specifications

General

Brand	Volcano
Model	SOLID VALVE
Category	Vaporizers
Language	English

Summary

Volcano Vaporizer Quick Start Guide

Switch heat on

Initiate heating process for the vaporizer, which takes approximately 3-5 minutes to reach temperature.

Choose temperature

Select the desired vaporization temperature for the substance being used.

Grind substance

Prepare the herbal material by grinding it to a fine consistency, between 1mm and 10mm.

Fill Filling Chamber

Load the ground substance into the filling chamber, ensuring it is not overfilled.

Insert Filling Chamber

Place the filled chamber into the Volcano unit, ensuring a secure connection.

Preheat substance

Allow the substance to preheat within the chamber, indicated by the control lamp.

Attach Valve Balloon

Connect the valve balloon securely to the filling chamber with an audible 'click'.

Watch vapor density

Observe the balloon filling with vapor, indicating successful vaporization.

Remove full Balloon Unit

Detach the filled balloon unit from the Volcano device once vapor production stops.

Detach Valve Balloon

Separate the valve balloon from the filling chamber after use.

Caution: Hot surface

Warning regarding hot surfaces on the filling chamber; do not leave it on the Volcano.

Attach Mouthpiece

Connect the mouthpiece to the valve balloon for inhalation.

Volcano Solid Valve Maintenance and Cleaning

Disassemble Valve Components

Step-by-step guide to dismantling the mouthpiece, valve cap, valve, and filling chamber parts.

Cleaning Procedures

Instructions for manual cleaning with alcohol (min. 90%) and dishwasher safety guidelines.

Attach New Balloon

Guide for cutting, preparing, and attaching a new balloon to the valve system.