volkano Allcast - Automatic Firmware Upgrade

7
The VolkanoX™ Allcast Wireless Receiver will upgrade its firmware automatically
when upgrades are detected.
• The Allcast Wireless Receiver needs to be connected to the internet through your
Wi-Fi Network to automatically detect, download and install firmware upgrades.
• Ensure that your Allcast Wireless Receiver has a good, stable connection to your
Wi-Fi Network for firmware upgrades as well as DLNA connections.
• Please do not attempt to operate or switch the Allcast Wireless Receiver off while the
upgrade is in progress.
• Pressing and holding the Reset Button will restore the Allcast Wireless Receiver
factory settings and close all previous connections.
Windows Devices (Miracast):
• Open the “Start Menu” and click on settings.
• Select “Devices” from the list of options.
• Select “Add Devices” and select “Wireless Display or Dock” in the pop-up window.
• Select “Allcast-xxxxxxxx” from the list of available devices and wait for the device to
connect. Enter the default password “12345678” if prompted.
Alternative Windows connection method:
• Press the short key “Win+P” on your keyboard.
• Select “Connect to a wireless display”.
• Select “Allcast-xxxxxxxx” to connect.
Apple MAC Devices (Screen Mirroring):
• Go to Wi-Fi
• Select “Allcast-xxxxxxxx” from the drop-down list.
• Enter the default password “12345678” and join.
• Open the Browser and type “192.168.49.1” and “Go”
• Select “Wi-Fi AP” from the results.
• Click “Scan” and select your Wi-Fi Network.
• Enter your Wi-Fi password and connect.
• Connect you Apple MAC device to the same Wi-Fi Network.
• On your Apple MAC device, open “System Preferences”, select “Displays” and then
select “Airplay Displays”
• Select “Allcast-xxxxxxxx” from the drop-down menu and wait for your device
to connect.
AUTOMATIC FIRMWARE UPGRADE