CONTROLS
AND
EQUIPMENT
Tur n
signal
and
main
beam
lever
Headlight flasher
Pull the lever towards the steering wheel to
the pressure point-the main beam warning
lamp will light up.
Parking lights
The parking lights only work when ignition
is switched off.
lever up (1)
lever down (2)
The turn signals only work when the ignition
is switched on.
Right turn signals - lever up (1)
Left turn signals - lever down (2)
When turn signals are working, the ap-
propriate warning lamp flashes as well - see
page 21.
The turn signals cancel automatically after
completing a
turn.
To signal a lane change
Move the lever up (1) or clown (2) to the
pressure point and hold in this position - the
warning lamp should flash.
Right parking lights -
Left parking lights -
If the ignition key has been removed, a buz-|
zer* will sound when the driver's door is *
open.
Motes
• The use of the signals and lighting de-
scribed here is subject to local regulations.
• If lights or turn signals are not switched
off, and the ignition key has been
with-
drawn,
a buzzer* will sound when the
driver's door is opened.
Switching main beam on/off
Pull the lever past the pressure point to-
wards the steering wheel (3)with dipped or
main beam on. When main beam is on, the
main beam warning lamp will light up.
64
LIGHTS
AND VISION
CONTROLS
AND
EQUIPMENT
interior
lights
Front interior Sight (A)
• Switch pressed on left - light perma-
nently on
• Switch in centre position - light off
Rear interior lights
Multivan,
Caravelle
and
Kombi
Switch positions:
„ . , . Interior light
• Switch pressed on right - controlled by permanently on ^
door contacts '
interior lights with delayed switch off* re- Door contact position
main on for about 6 seconds after doors are Qf)-
ciosecl.
•CD
O
Front reading light* (B)
• Switch pressed on left - Light off
• Switch pressed on right - light perma-
nently on
LIGHTS
AND VISION
•
65
To Next Page
Loading...
