CONTROLS
AND
EQUIPMENT
| B70-766C 1
4 -
Adjusting
pivoting
seats*
Pull
lever up at side of the seat and
turn
seat.
It might be necessary to push the seat
for-
ward slightly or open the doors before turn-
ing the
seats.
Warning
•
Before
rotating
the
driver's
seat
the
handbrake
must
first
be
released. The
vehicle
must
there-
fore
be
prevented
from
rolling
by
some
other
method
(e.g.
gear
en-
gaged).
•
Before
rotating
the
front
pass-
enger
seat
the
handbrake
must
first
be
engaged
or the
vehicle
must
be
prevented
from
rolling
by some
other
method
(e.g.
gear
engaged).
•
When
the
vehicle
is
moving
the
seats
must
be
facing
forward
and
properly
secured.
5 -
Adjusting
armrests*
The armrests on the
front
seats can be
hinged up if they are not required.
The angle of the armrests can be adjusted
as
required
with
a knurled knob, underneath
the armrest.
6 -
Adjusting
backrest
Take
weight off backrest and
turn
knob.
Warning
Do not
have
the
backrest
set too
far
back
whilst
the
vehicle
is
moving
because the
seat
belts
are
then
no
longer
fully
effective.
7 -
Drinks/can
holder*
The procedure for opening the drinks holder
on the passenger side and what should be
noted when doing so
is
detailed on page 104.
76
SEATS AND STOWAGE
CONTROLS
AND EQUIPMENI
Head restraints
The
front
and rear* head restraints are ad-
justable for height and should be set to suit
the
size
of the person in the seat. Correctly
adjusted head restraints, together
with
properly worn seat belts, offer effective
protection.
Adjusting
height
• Grip sides of head restraint
with
both
hands and pull up or push down.
• The best protection is obtained when the
upper edge of restraint is at
least
at eye
level.
Removing
and
installing
To
remove, pull restraints up to the stop,
press
button
in direction of the arrow and at
the same time take restraints out.
To
install again, push the restraint rods
into
the guides
until
they are heard to engage.
Note
On
some models, head restraints are
fitted
which differ from the version illustrated and
can
be removed and installed as described
below.
Spring clip
version
To
remove the spring clips from the seat
backrest guide rings, pull or push the clip
out to one side
with
a small screwdriver.
When reinstalling, insert the head restraint
first,
and then push the spring clips in so
that
the straight leg is at the rear.
SEATS AND STOWAGE 11
To Next Page
Loading...
